You can take the chill off your workbench for a Saturday project with a portable electric heater. Keeping the whole garage comfortable for morning workouts takes more heat. A mini split makes sense when you use the space regularly and want summer cooling too. For a large workshop with a high heating load, a vented gas heater is worth pricing if gas service is already nearby.
Think about what happens when you pull the car out on a January morning. In a finished garage with a well-sealed door, a DELLA mini split may have enough capacity to keep the room comfortable through winter. An older garage with bare walls and daylight under the overhead door can lose heat quickly. How warm you need the space to stay, and how quickly you need it to warm back up, will shape the choice.
Key Takeaways
Heat the area you actually use. A portable heater can warm a workbench area for a few hours. Regular use across the whole garage calls for equipment sized to the building’s heat loss.
Ask for heating output at your local winter design temperature. Use that figure to see whether a mini split can cover the garage’s load in cold weather.
Compare the installed price and running cost separately. A new circuit, gas line, or vent can change the upfront cost. Your utility rates and heating schedule determine what you’ll pay to run it.
How Much Heating Do I Need for My Garage?
Start with the square footage you want to heat and how warm you need it to stay. The table uses rough allowances of 25 BTU/hr per square foot for a moderate climate and 50 for a cold climate. For a 20-by-20-foot garage, those assumptions give preliminary estimates of 10,000 and 20,000 BTU/hr, respectively. Measure the floor area first, since a deep two-car garage can have as much space as a compact three-car garage.
| Garage size | Moderate climate (BTU/hr) | Cold climate (BTU/hr) |
| 1-car, 240–540 sq. ft. | 6,000–13,500 | 12,000–27,000 |
| 2-car, 400–720 sq. ft. | 10,000–18,000 | 20,000–36,000 |
| 3-car, 600–1,080 sq. ft. | 15,000–27,000 | 30,000–54,000 |
Those ranges are a starting point. A 480-square-foot garage kept at 45°F for storage will generally need less heat than the same garage kept at 65°F for woodworking. When you’re sizing a garage mini split, give the installer both the floor dimensions and the temperature you expect the system to maintain.
What Is the Best Way to Heat a Garage?
The choice gets clearer once you know how much of the garage you need to heat and how often you’ll use it. The table shows which options are worth a closer look for each situation.
| Heating option | Best fit | What to check first |
| Mini split heat pump | Regular use in winter and summer | Heating output in cold weather |
| Vented gas heater | Larger shop with a high heating load | Gas supply and exhaust route |
| Portable electric heater | Short projects in one work area | Outlet condition and safe clearances |
| Fixed electric heater | Permanent heating where gas is impractical | Circuit capacity and electricity rates |
| Radiant floor or ground-source heat pump | New slab or larger building project | Installation scope and upfront cost |
Mini Splits for Heating and Cooling
The same garage that feels too cold for a January workout can get stuffy by midafternoon in July. The DELLA Vario 18,000 BTU Mini Split Heat Pump handles both seasons with one system. The model’s AHRI certificate lists 18,000 BTU/hr of cooling and 19,000 BTU/hr of heating at an outdoor temperature of 47°F. Where the overhead door opens often or the walls and ceiling have thin insulation, compare the model’s available heat at your local winter design temperature with the garage’s calculated heat loss. Tell your installer if you also need the space to warm back up quickly after each door opening.
Where Vented Gas Heaters Make Sense
Vented gas heat is worth pricing for a detached workshop that needs substantial heat and already has gas service nearby. Ask for the unit’s heating output in BTU/hr so you can compare it with the garage’s heat loss. The input rating describes the fuel energy the heater uses. For a residential garage, look for equipment approved for that setting. Separated-combustion models draw combustion air from outside and vent the exhaust outdoors.
Portable Electric Heat for Weekend Projects
Working at one bench for a couple of hours? A 1,500-watt portable heater provides about 5,100 BTU/hr at full power, which can take the chill off the occupied area. Use a model whose instructions allow the location. Place it at least 3 feet from anything that can burn, plug it directly into a wall outlet, and turn it off when you leave.
What a Fixed Electric Heater Adds
Wall- or ceiling-mounted electric heat frees up floor space and can offer more output than a plug-in heater when the electrical supply supports it. It can suit a shop that needs permanent, thermostat-controlled heat and has no convenient gas supply. Get the wiring priced with the heater, then compare its running cost with a mini split if you’ll be heating the garage most days.
Radiant Floors and Ground-Source Heat Pumps
Radiant floor heating is easiest to consider when you’re already pouring or replacing a slab. It suits a shop you keep warm for long stretches because the slab takes time to heat up. A ground-source heat pump delivers heat using a ground loop and can be part of a broader heating project. Ask whether an existing ground-source system has spare capacity before pricing a new loop just for the garage.
How to Heat a Garage in Winter
In winter, a heater may hold the temperature with the overhead door closed but take longer than you’d like to recover after a vehicle comes in. Give the installer your target temperature and describe a typical day of door use so the estimate reflects both needs.
Heating Capacity on the Coldest Days
Have the contractor put two figures side by side: the garage’s heat loss at the local winter design temperature and the equipment’s available heating output at that same temperature. When comparing 18,000 BTU mini splits, ask for the exact model’s extended performance data. For example, a garage that loses 16,000 BTU/hr still needs another 3,000 BTU/hr if the proposed unit can deliver only 13,000 BTU/hr at the design temperature. You can close that gap by reducing heat loss, choosing different equipment, or planning supplemental heat.
Why Equal-Size Garages Need Different Heat
Two garages with matching floor plans can lose heat at very different rates. Before comparing garage heating and cooling options, walk through the space and note what an installer will need to account for:
Door seals. With the overhead door closed, look for daylight where the bottom seal meets the slab or along the sides.
Walls and ceiling. Note which surfaces are insulated and which face outdoors or adjoin the heated house.
Ceiling height. Measure to the ceiling or roof deck as applicable, and point out open rafters or a loft that could affect airflow.
Door traffic. Tell the installer how often the overhead door opens and how quickly you need the work area comfortable again.
What Does It Cost to Heat a Garage?
The equipment price is only one part of the bill. Compare quotes for a working installation first, then use your local utility rates to see how much each option would cost to deliver the same heat.
Equipment, Labor, and Utility Upgrades
Ask contractors to itemize equipment, labor, utility hookups, and any required permits. A quote for a mini split system should make clear whether the circuit, outdoor mount, line set, drain, and startup are included. For gas, look for the supply line and exhaust vent. Confirm which items require a separate electrician or gas contractor before comparing totals.
How Much Does the Same Heat Cost?
The table compares what it costs to deliver 100,000 BTU of heat with electric resistance, natural gas, or a mini split for garage heating. The example uses sample utility rates and assumes the mini split has a coefficient of performance (COP) of 2.5. That means it delivers 2.5 units of heat for every unit of electricity it uses under those conditions. To estimate your own cost, use your local utility rates and the model’s COP at a temperature typical of your winter.
| Heating option | Example assumptions | Cost per 100,000 BTU delivered |
| Electric resistance | $0.16/kWh, 29.3 kWh | $4.69 |
| Mini split | $0.16/kWh, COP of 2.5, about 11.7 kWh | $1.88 |
| Natural gas | $1.50/therm, 80% delivered efficiency, 1.25 therms | $1.88 |
At $0.16/kWh for electricity and $1.50/therm for natural gas, a mini split costs less per unit of heat than an 80% efficient gas heater when its COP is above about 2.5. Below that point, gas costs less. These figures cover energy use and exclude installation, fixed utility charges, and electricity for the gas heater’s blower. For propane, run a separate estimate using your local price per gallon and the quoted heater’s efficiency.
Weekend Use vs. Daily Heating Costs
Two three-hour sessions a week add up to 24 hours over four weeks. Five four-hour sessions a week add up to 80 hours. At $0.16/kWh, a 1,500-watt plug-in heater running at full power throughout those sessions would cost $5.76 and $19.20, respectively. When estimating a permanent system, also account for warm-up time and any hours you plan to keep the garage heated while it’s empty.
What Does Each Garage Heater Need for Installation?
Take photos of the proposed heater location, the garage-door tracks, and the outside wall where a line set or vent might exit. Share them when you look for an HVAC installer so the contractor can flag obvious placement issues before the site visit.
When Electric Heat Needs a Dedicated Circuit
The model’s electrical specifications tell the electrician what circuit the equipment needs. Before ordering a hardwired heater or mini split, have them check panel capacity and, for a detached garage, whether the existing electrical supply can carry the added load. With a portable heater, stop using it if the plug or outlet gets hot and have the outlet checked.
Space and Drainage for a Mini Split
Open the overhead door fully before settling on an indoor mounting spot. Check that the tracks, shelving, and overhead storage leave room for the unit and its airflow. Outside, use cold-weather mini split placement tips to identify a spot with clearance above expected snow buildup. Ask the installer to show where indoor condensate will drain in summer and where outdoor defrost water can go in winter without icing over a walkway.
Gas Lines, Exhaust Vents, and Permits
Have a qualified installer check the gas supply and identify an approved vent location before you order the heater. Ask where the intake and exhaust will terminate, how they’ll clear nearby doors and windows, and who will handle any locally required permits and inspections. For propane, confirm that the quote covers the correct fuel configuration.
Heater Clearances and Carbon Monoxide Safety
Check the heater’s required clearances with a vehicle parked and the overhead door open. Keep gasoline, solvents, and other flammable materials away from ignition sources. In a home with an attached garage, place carbon monoxide alarms on every level and outside sleeping areas. Never run a vehicle inside an attached garage, even with the overhead door open.
FAQs
What Is the Best Way to Heat an Uninsulated Garage?
For a quick project, heat the area around your workbench while you’re there. For regular use, fix the largest air leaks and insulate exposed surfaces before committing to permanent equipment. You’ll get a more useful estimate of the capacity the garage will need after those improvements.
Is a heated garage bad for cars?
Heated parking can be fine for your car. Pay attention to the salty slush that collects underneath it and in the wheel wells. Wash the undercarriage after driving on heavily salted roads and clear pooled meltwater from the garage floor so the area can dry.
What’s the best garage temperature in winter?
Set the temperature for what you keep or do in the garage. For storage, check the minimum temperature for the most sensitive item. For workouts or projects, warm the space when you’ll use it. If you have plumbing, put a thermometer near the most exposed pipe and check it during a cold snap. The temperature there can be lower than the thermostat reading.
Can I install a heating system in a metal garage?
Yes. Start by having the installer verify what can support the equipment and how the wall penetrations will be sealed. Mention any condensation you’ve noticed, especially droplets on the underside of the roof, so the contractor can account for moisture when planning the insulation and heating.
Conclusion
For a garage you use most days, ask for a quote that shows the calculated heat loss, the heater’s available output at your local winter design temperature, and the full installed price. Those numbers tell you whether the system can keep the garage comfortable and what it will cost to get it running. When you only need warmth for an occasional project, heating the workbench area may be all the garage needs.
